Saltar al contenido principal

Olympus Stylus Tough-8010 Side Panel Replacement

Qué necesitas

  1. Olympus Stylus Tough-8010 Side Panel Replacement, Side Panel: paso 1, imagen 1 de 3 Olympus Stylus Tough-8010 Side Panel Replacement, Side Panel: paso 1, imagen 2 de 3 Olympus Stylus Tough-8010 Side Panel Replacement, Side Panel: paso 1, imagen 3 de 3
    • Remove the three screws (3.2mm) from the front panel using a T-6 screwdriver.

    • Take off the smaller front panel cover.

    • Carefully remove the larger front cover.

  2. Olympus Stylus Tough-8010 Side Panel Replacement: paso 2, imagen 1 de 3 Olympus Stylus Tough-8010 Side Panel Replacement: paso 2, imagen 2 de 3 Olympus Stylus Tough-8010 Side Panel Replacement: paso 2, imagen 3 de 3
    • Remove the top two screws (4.1mm) using a #000 Phillips head screwdriver.

    • Remove the two screws (7.9mm) near the control pad. Set metal connector aside.

    • Remove the side panel casing.

  3. Olympus Stylus Tough-8010 Side Panel Replacement: paso 3, imagen 1 de 3 Olympus Stylus Tough-8010 Side Panel Replacement: paso 3, imagen 2 de 3 Olympus Stylus Tough-8010 Side Panel Replacement: paso 3, imagen 3 de 3
    • Using a #000 Philips head screwdriver, remove the two screws (4.1mm) on the right side of the camera.

    • Remove the two screws (4.1mm) from the bottom of the camera.

    • Remove the single screw (3.2mm) from the front of the camera.

  4. Olympus Stylus Tough-8010 Side Panel Replacement: paso 4, imagen 1 de 2 Olympus Stylus Tough-8010 Side Panel Replacement: paso 4, imagen 2 de 2
    • Carefully remove the front panel piece.

    • Remove the screw (7.9mm) from the bottom left hand corner using a #000 Phillips head screwdriver.

  5. Olympus Stylus Tough-8010 Side Panel Replacement: paso 5, imagen 1 de 3 Olympus Stylus Tough-8010 Side Panel Replacement: paso 5, imagen 2 de 3 Olympus Stylus Tough-8010 Side Panel Replacement: paso 5, imagen 3 de 3
    • Slightly bend the metal that is covering the side panel axle.

    • Using a paperclip, completely push out the metal bar that holds the side panel to the camera.

    • Remove the side panel door.

Conclusión

To reassemble your device, follow these instructions in reverse order.

James G Payne

Miembro Desde 03/23/15

225 Reputación

2 Guías creadas

Equipo

Baylor, Team 7-15, Williams Spring 2015 Miembro de Baylor, Team 7-15, Williams Spring 2015

BU-WILLIAMS-S15S7G15

3 Miembros

12 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 2

Todo El Tiempo: 335