Olympus Stylus 1010 Lens Replacement

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

This guide gives instructions on how to access and remove the lens from the Olympus Stylus 1010. Before proceeding make sure you have removed the case from the Olympus Stylus 1010.

Qué necesitas

Paso 1 Disassembling Olympus Stylus 1010 Case

Olympus Stylus 1010 Lens Replacement, Disassembling Olympus Stylus 1010 Case: paso 1, imagen 1 de 2

Olympus Stylus 1010 Lens Replacement, Disassembling Olympus Stylus 1010 Case: paso 1, imagen 2 de 2

Remove the five Phillips #00 bottom and right side panel screws.

Traducir

Paso 2

Remove the right side panel by pulling off the large silver piece.

Traducir

Paso 3

Remove the remaining three Phillips #00 side and front panel screws.

Traducir

Paso 4

Using your thumb and forefinger, pull off the silver name plate and silver "T-shape" piece.

Traducir

Paso 5

Remove the black front panel by sliding it towards the lens and then pulling it up off of the camera.

Traducir

Paso 6

Olympus Stylus 1010 Lens Replacement: paso 6, imagen 3 de 3

Remove the three Phillips #00 screws from the front of the camera.
Using a spudger, lift the two tabs to separate the case—one tab on top and one tab on the right side.

Traducir

Paso 7

Olympus Stylus 1010 Lens Replacement: paso 7, imagen 3 de 3

Using a plastic spudger, lift up the black clips.
Still using the plastic spudger, detach the gold connector strip and white connector strip.
Using both hands, pull the camera apart into two pieces.