Repara tus cosas Comunidad Tienda

Nostalgia Electrics PCM805 Power Switch Replacement

Introducción

Use this guide to replace the switch if the device will not turn on when receiving power.

Qué necesitas

  1. Nostalgia Electrics PCM805 Power Switch Replacement, Unscrewing the base: paso 1, imagen 1 de 2 Nostalgia Electrics PCM805 Power Switch Replacement, Unscrewing the base: paso 1, imagen 2 de 2

    • Unplug the device before following this guide.

    • First, place the device on its side, making sure the switch is not facing down.

    • Remove the eight 12mm Phillips #02 screws from the base.

    Editar

  2. Nostalgia Electrics PCM805 Power Switch Replacement: paso 2, imagen 1 de 1

    • Gently separate the panel from the device.

    • Be sure not to tug at the wires that are still connected.

    Editar

  3. Nostalgia Electrics PCM805 Power Switch Replacement, Power Switch: paso 3, imagen 1 de 1

    • Locate the switch/wire assembly inside the device.

    Editar

  5. Nostalgia Electrics PCM805 Power Switch Replacement: paso 4, imagen 1 de 1

    • Pull back the insulation sleeves to expose the connector heads.

    Editar

  6. Nostalgia Electrics PCM805 Power Switch Replacement: paso 5, imagen 1 de 2 Nostalgia Electrics PCM805 Power Switch Replacement: paso 5, imagen 2 de 2

    • Note the color of each wire and the order you remove them.

    • Using a pair of pliers, firmly grip the base of the wire.

    • Be sure to grip where the connector meets the wire and not where the connector covers the switch prong.

    • Pull the wire straight out of the switch.

    • Repeat this step for each wire.

    Editar

  7. Nostalgia Electrics PCM805 Power Switch Replacement: paso 6, imagen 1 de 2 Nostalgia Electrics PCM805 Power Switch Replacement: paso 6, imagen 2 de 2

    • Using pliers, pinch tabs at the top and bottom of switch.

    • While pinching the tabs, push the switch until the tabs are on the outside of the device.

    Editar

  8. Nostalgia Electrics PCM805 Power Switch Replacement: paso 7, imagen 1 de 2 Nostalgia Electrics PCM805 Power Switch Replacement: paso 7, imagen 2 de 2

    • Remove the switch from the device.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 4 otros colaboradores

Carlton

Miembro Desde 01/13/15

672 Reputación

5 Guías creadas

Insignias: 13

+ 10 más insignias

Equipo

USF Tampa, Team 3-5, Hickman Winter 2015 Miembro de USF Tampa, Team 3-5, Hickman Winter 2015

USFT-HICKMAN-W15S3G5

5 Miembros

8 Guías creadas

Un comentario

The red light turns on but the disk isnt spinning or heating up and when the out let has power

Manuela Velez - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 7

Todo El Tiempo: 1,939