Nook BNRV300 Back Cover Replacement

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

To replace any of your Nook’s other components, you must first remove the back cover. This guide demonstrates the steps you will need in order to remove the Nook BNRV300 back cover. This device is also called the “Nook Simple Touch.”

Before working on your device, remove the microSD card (if there is one). This will protect the memory of your card. The microSD card is located in a slot on the upper right side of the device.

This guide will enable access to the battery, motherboard, and display.

Qué necesitas

Paso 1 Power Button

Nook BNRV300 Back Cover Replacement, Power Button: paso 1, imagen 1 de 3

Nook BNRV300 Back Cover Replacement, Power Button: paso 1, imagen 2 de 3

Nook BNRV300 Back Cover Replacement, Power Button: paso 1, imagen 3 de 3

Power off your Nook before working on your device. Hold the power button for about 5 seconds and select the “Power Off” option.
Turn the Nook over to find the power button along the back upper edge.
Wedge the spudger between the top of the power button and the upper edge of the device.
Push the tool down to pry the button up and off.

Traducir

Paso 2

Using your fingers, take off the power button.

Traducir

Paso 3 Back Cover

Nook BNRV300 Back Cover Replacement, Back Cover: paso 3, imagen 1 de 3

Nook BNRV300 Back Cover Replacement, Back Cover: paso 3, imagen 2 de 3

Nook BNRV300 Back Cover Replacement, Back Cover: paso 3, imagen 3 de 3

Peel off the white sticker that is covering the screw head.
Remove the one 2mm-long screw using a size T5 Torx screwdriver.

Traducir

Paso 4

Wedge an opening tool between the back cover and the front plastic border at the top of the device (near the power button).
This will require some force.
Slide the opening tool along the edges of the device, prying up until you are able to use your fingers to remove the back cover.
The back cover snaps as it pops off. This is normal.