Introducción

This guide requires that the front plate and keypad already be removed. You will have to remove 6 screws and separate the circuit board from the rest of the phone.

Partes

No se requieren partes.

Pull up on both of the clips near the bottom of the phone as shown.
  • Pull up on both of the clips near the bottom of the phone as shown.

  • Lift off the front plate.

Agregar Comentario

The keypad and LCD screen are revealed.
  • The keypad and LCD screen are revealed.

Agregar Comentario

  • Separate the keypad from the phone and place aside.

  • Wipe off any excess dust from where the keypad was attached to the phone.

Agregar Comentario

  • Remove the 6 - 7.9 mm screws highlighted by the markers using the T-6 head on the screwdriver.

Agregar Comentario

  • Separate the inside of the phone from the back of the phone.

Agregar Comentario

  • Gently pull apart the circuit board from the rest of the phone.

  • There is a small connector holding these two pieces together, so use caution when pulling apart so as not to damage it.

Agregar Comentario

Conclusión

To reattach the circuit board, line up the connector at the top of the board with the back of the LCD Screen attachment. Place the two boards together, and screw in the 6 screws.

Reid Polstra

Miembro Desde 22/10/12

1 Reputación

7 Guías creadas

Equipo

Clemson, Team 15-5, Benson Fall 2012 Miembro de Clemson, Team 15-5, Benson Fall 2012

CLEM-BENSON-F12S15G5

3 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 600