Introducción

Removing the outer display from the Nokia 6102i

Partes

No se requieren partes.

  1. This step does not require much force.
    • This step does not require much force.

    • Use the plastic opening tool to pry between the seam of the black phone cover which is located at the base of the screen.

    Agregar Comentario

  2. Have a container ready to keep track of small parts.
    • Have a container ready to keep track of small parts.

    • Use the t6 screwdriver to remove the two visible screws that are immediately below the screen.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Keep the phone closed, and slide the Ipod tool between the the silver and black phone case. Use the tool to slide all the way around the case to release the catches.

    Agregar Comentario

    • Pull out the circuit board, which will remove it completely from the case

    Agregar Comentario

    • If the metal case is not already free, simultaneously release the metal tabs on both sides of the metal casing to remove the display screen.

    Agregar Comentario

    • Be gentle when pulling off the display screen. If pulled too hard, the orange connecting ribbon will rip.

    • Lift off the display screen and disconnect it from the circuit board.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

Cal Poly, Team 23-78, Johann Spring 2010 Miembro de Cal Poly, Team 23-78, Johann Spring 2010

CPSU-JOHANN-S10S23G78

4 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 2

Todo El Tiempo: 2,612