Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip over the phone so that the back is facing up.
-
Pressing your thumb against the back cover, slide the cover off of the phone.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
With the phone closed, run a plastic opening tool along the seam of the top half of the phone.
-
Make sure to disconnect each of the five clips before proceeding to the next step.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four 3.2 mm screws from the front panel using a T6 Torx screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Starting in the lower right corner, slowly begin to lift the tape that is holding down the front LCD and cables.
-
Lift the tape from the board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a plastic opening tool, lift the ribbon cable connection below the front LCD.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a plastic opening tool, slowly pry the LCD display from the bottom, releasing it from the glue that is holding it to the board.
-
Cancelar: No complete esta guía.
2 personas más completaron esta guía.