Partes

No se requieren partes.

  1. Slide the back cover down with your thumb.
    • Slide the back cover down with your thumb.

    • *Note: the battery cover is not shown in this picture

    Agregar Comentario

  2. Gently lift the battery with a fingernail and remove it from its housing.
    • Gently lift the battery with a fingernail and remove it from its housing.

    • *Note: the battery may be replaced or repaired at this step

    Agregar Comentario

    • On some models, the front case is screwed down from the back. Follow steps 5 and 6 FIRST to remove the camera cover and two T6 screws, before removing the faceplate.

    • Use the Spudger to gently pry up the edges of the front face plate

    • At the center of the faceplate edge below the music keys there is a small latch on each side.

    Before doing this step, first remove the camera cover and the two t6 screws from the back (steps 5 and 6). Otherwise you will break the cover. This may be a factor only for some revisions (RM-304)

    s c - Contestar

    • Lift up the keypad from the bottom with either the spudger or your finger.

    • Note: at this time the keypad can be removed and replaced

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

5 personas más completaron esta guía.

Max Kirby

Miembro Desde 01/05/11

515 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 15-14, Regan Spring 2011 Miembro de Cal Poly, Team 15-14, Regan Spring 2011

CPSU-REGAN-S11S15G14

3 Miembros

8 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 6

Últimos 30 Días: 12

Todo El Tiempo: 5,356