Introducción

Describes how to replace the screen of the Nokia 3300B.

Partes

No se requieren partes.

  1. Flip the Nokia 3300B over with the back-side facing towards you.
    • Flip the Nokia 3300B over with the back-side facing towards you.

    • Gently press the button on the back of the battery cover to release the cover and slide up.

    Agregar Comentario

  2. Lift the battery out of the back of the phone.
    • Lift the battery out of the back of the phone.

    • It is easiest to lift the battery out of the phone from the right-hand side, as seen in the picture.

    Agregar Comentario

    • Gently push the blue tabs on the top of the phone out of their slots.

    • With the phone facing up, pop the blue faceplate off by using your fingernail (or some tweezers) and working your way around the phone.

    • Note: If the blue cover does not detach easily use your finger nails to try and split it open, as seen in the picture.

    Agregar Comentario

    • With the screen still facing you, remove the blue faceplate.

    Agregar Comentario

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Grab the sides of the keypad and lift it up vertically.

    • If you encounter resistance while removing the keypad, be sure to lift up evenly on both sides, so the button's pin don't snap.

    Agregar Comentario

    • Using the Torx T6 bit of a Phillips precision screwdriver, remove the six screws on the phone's inner protective case, as seen in the picture.

    • NOTE: Be sure to save these screws so the phone can be reassembled later.

    Agregar Comentario

    • Holding the phone with the screen facing you, remove the top half of the phone from the circuit board.

    Agregar Comentario

    • Hold the top half of the phone with the screen facing you.

    • Using a pair of tweezers, release the tabs holding the two distinct cases together.

    • The tabs are very fragile. Be gentle when releasing the tabs.

    Agregar Comentario

    • Be sure to remove both casings so that the screen is facing down. This will ensure that the screen does not fall out of its case.

    • NOTE: The screen's part identification sticker is on the top back side of the screen. The screen will need to be replaced with the same orientation.

    Agregar Comentario

    • Tilt the casing back and the screen should fall out smoothly.

    • Replace the old screen with the new screen.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Chris Colwell

Miembro Desde 13/04/10

77 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 18-65, Johann Spring 2010 Miembro de Cal Poly, Team 18-65, Johann Spring 2010

CPSU-JOHANN-S10S18G65

4 Miembros

9 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 3

Todo El Tiempo: 2,895