Introducción

If the phone's problem lies in the logic board, use this guide to change the logic board out.

Partes

No se requieren partes.

Be sure cell phone is off before you begin to disassemble the phone.
  • Be sure cell phone is off before you begin to disassemble the phone.

  • Press the button on the bottom of the back of the cell phone.

  • Slide rear panel down and remove it.

Agregar Comentario

Using your fingernail, pry the back of the battery upwards and pull out.
  • Using your fingernail, pry the back of the battery upwards and pull out.

Agregar Comentario

  • Insert the plastic opening tool under the faceplate.

  • Separate the faceplate from main body by twisting the prying tool with some force.

  • The faceplate is held by three plastic fasteners, so pry evenly on both sides of phone.

Agregar Comentario

  • With the faceplate removed, simply peel off rubber key pad and remove.

Agregar Comentario

  • Locate and remove the six screws on the front of the phone using a T6 Torx.

    • All 6 screws are 6.9mm long.

Agregar Comentario

  • After removing screws, lift the motherboard assembly straight off the cell phone body.

Agregar Comentario

  • Locate the two plastic LCD unit hooks.

  • Pry hooks outward.

Agregar Comentario

  • Gently pull LCD unit away from the logic board.

    • Be careful not to damage the connection on the top, right hand side of the logic board.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Chad

Miembro Desde 29/10/10

10 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 20-8, Maness Fall 2010 Miembro de Cal Poly, Team 20-8, Maness Fall 2010

CPSU-MANESS-F10S20G8

4 Miembros

28 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 1,170