Nintendo Wii U Pro Controller Joystick Replacement

Introducción

In this disassembly, we will be removing the back cover which will allow us to access the internal components of the controller. Once this is removed, we will be pulling back the joysticks which will allow us to tackle several different tasks. This guide shows users how to replace defective and/or broken batteries as well as joysticks in their Wii U Pro controller.

Qué necesitas

Paso 1 Battery

Nintendo Wii U Pro Controller Joystick Replacement, Battery: paso 1, imagen 1 de 1

Turn the controller over to reveal the battery cover.
Use the J000 screwdriver to remove the screw that secures the battery cover.

Traducir

Paso 2

Remove the battery from the controller by inserting the plastic spudger into the small gap on the bottom right of the battery.
Use the spudger as a lever to pry up and remove the battery from the compartment.

Traducir

Paso 3 Joystick

Nintendo Wii U Pro Controller Joystick Replacement, Joystick: paso 3, imagen 1 de 1

Remove the eight 5.5 mm Y0 screws.

Traducir

Paso 4

Now that you have removed all of the screws, separate and remove the bottom half of the controllers shell from the top half.

Traducir

Paso 5

Make replacement easier.
Move the right trigger and sensor (Indicated by the red arrow in the picture on the left) out of the way.
Remove the 4 mm J0 screw.

Traducir

Paso 6

For the other joystick, repeat the same process as in step 6.
Move the left trigger and sensor (Indicated by the red arrow in the picture on the left) out of the way.
Remove the 4 mm J0 screw.

Traducir

Paso 7

Remove the joysticks from the controller’s shell as shown in the picture.

Traducir

Paso 8

Remove the joysticks from the circuit board.
Carefully pull the rubber thumbsticks off of the electronic bearings. With the old joysticks removed, the controller is now ready for new replacements.

Traducir