Introducción
Utiliza esta guía para retirar la carcasa exterior de la Nintendo Wii U y acceder a la unidad de DVD.
Qué necesitas
-
-
Con la parte inferior de la consola hacia arriba, retira los siguientes 6 tornillos ocultos debajo de las pegatinas cuadradas blancas:
-
Tres tornillos Phillips #000 de 5,1 mm
-
Dos tornillos Tri-wing Y0 de 6,1 mm
-
Un tornillo Tri-wing Y1 de 13,2 mm
-
-
-
Gira la consola 180 grados de modo que las rejillas de escape queden orientadas hacia ti.
-
Retira los dos tornillos Phillips #00 de 7,1 mm.
Both screws are not “7.1mm” in length, only the one to the right is (center of the console’s side). The left one (towards the front of the console) is 5.1mm.
There’s a third screw to remove bottom-left corner of this picture. On step 9 it’s already been removed, and you need it to be removed in order to remove the metal casing in step 13.
-
-
-
-
En la parte posterior de la consola, levanta y libera la cubierta superior principal.
The front portion of the side of the cover with the vents was kind of stuck on mine. There’s a little rubber piece in there that was the cause of this. But that same rubber piece also makes up the little handle-shaped nub that sticks out of the side there. (There’s also one at the back of the same side, but that one didn’t stick for me.) Lifting also using the little handle made it easy to remove the cover.
-
Para volver a montar el dispositivo, sigue estas instrucciones en orden inverso.
Para volver a montar el dispositivo, sigue estas instrucciones en orden inverso.
Cancelar: No complete esta guía.
27 personas más completaron esta guía.
Un agradecimiento especial a estos traductores:
100%
¡ Carlos López (España - Spain) nos está ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›