Saltar al contenido principal

Nintendo Wii Remote Sensor Screen Replacement

Qué necesitas

  1. Nintendo Wii Remote Sensor Screen Replacement, Front Cover Plate and Batteries: paso 1, imagen 1 de 2 Nintendo Wii Remote Sensor Screen Replacement, Front Cover Plate and Batteries: paso 1, imagen 2 de 2
    • Flip the Wii Remote over so the battery cover faces you.

    • Push up on the bottom tab.

    • Remove the battery cover.

  2. Nintendo Wii Remote Sensor Screen Replacement: paso 2, imagen 1 de 1
    • Remove the first battery by pressing down on the positive end and pulling the battery out.

    • Remove the second battery by pushing up on the positive end and pulling the battery out.

  3. Nintendo Wii Remote Sensor Screen Replacement: paso 3, imagen 1 de 1
    • Using a tri-point Y1 Screwdriver, remove the two center 7mm screws by turning them counterclockwise.

    • Repeat with the two bottom screws.

  4. Nintendo Wii Remote Sensor Screen Replacement: paso 4, imagen 1 de 2 Nintendo Wii Remote Sensor Screen Replacement: paso 4, imagen 2 de 2
    • With the flat end of a spudger, gently apply pressure to the tabs located on left side of the controller.

    • These tabs are breakable. However, if the tabs are broken the controller will still function.

    • Open the front plate like a book.

    • Small parts may fall out as you open the front plate.

    Mine is not opening like a book? What do I do?

    Micah Thompson - Contestar

    It stops short of explaining replacing rechargeable battery. Unless you’re referring to the AA’s which don’t involve removing cover

    Sticky Insides - Contestar

  5. Nintendo Wii Remote Sensor Screen Replacement, Sensor Screen: paso 5, imagen 1 de 3 Nintendo Wii Remote Sensor Screen Replacement, Sensor Screen: paso 5, imagen 2 de 3 Nintendo Wii Remote Sensor Screen Replacement, Sensor Screen: paso 5, imagen 3 de 3
    • Tilt the remote, without the front cover plate, upward so the handle strap is at the bottom and the black screen is facing you.

    • Grip the outward edge of the screen with your fingers.

    • Gently, pull the screen straight outward from its housing. The screen will slide directly out.

Conclusión

To reassemble your device, follow these instructions in reverse order.

11 personas más completaron esta guía.

Emily

Miembro Desde 04/14/13

1,479 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 3-44, Amido Spring 2013 Miembro de Cal Poly, Team 3-44, Amido Spring 2013

CPSU-AMIDO-S13S3G44

4 Miembros

26 Guías creadas

2 comentarios

Where can the screen be purchased??

cutsiepie6480 - Contestar

how is this moderate difficulty

Sqwerks - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 4

Ultimos 7 días: 55

Ultimos 30 días: 247

Todo El Tiempo: 20,163