Introducción

This guide will help you remove the front panel of the controller. It is a prerequisite guide only.

Partes

No se requieren partes.

  1. Pull down on the battery cover release lever and pull back to remove the cover.
    • Pull down on the battery cover release lever and pull back to remove the cover.

    Agregar Comentario

  2. Take out each battery then put the covering back on.
    • Take out each battery then put the covering back on.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Remove the eight 9-mm Tri-Wing screws on the back panel with the Tri-wing Y1 screwdriver.

    • During reassembly, firmly hold the panels of the controller together while replacing screws so the panels don't separate.

    Agregar Comentario

    • After each screws has been removed carefully turn over the controller, and place on a flat surface.

    • Slowly separate the top panel from the bottom panel.

    • The buttons are loose and may fall off of the motherboard.

    • Once seperarted set aside the top panel.

    • During reassembly, make sure the front panel lines up with the buttons so they slide back into place.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

JT Gryder

Miembro Desde 12/04/13

51 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 10-40, Amido Spring 2013 Miembro de Cal Poly, Team 10-40, Amido Spring 2013

CPSU-AMIDO-S13S10G40

4 Miembros

20 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 9

Todo El Tiempo: 814