Repara tus cosas Comunidad Tienda

Nintendo GameCube Front and Back Panel Replacement

Introducción

Removing these panels allows further access to the GameCube's components.

Qué necesitas

  1. Nintendo GameCube Front and Back Panel Replacement, Top Case: paso 1, imagen 1 de 3 Nintendo GameCube Front and Back Panel Replacement, Top Case: paso 1, imagen 2 de 3 Nintendo GameCube Front and Back Panel Replacement, Top Case: paso 1, imagen 3 de 3

    • Turn over the Gamecube so that the bottom side is facing up.

    • Use the 4.5 mm Gamebit screwdriver to remove all four screws.

    Traducir

  2. Nintendo GameCube Front and Back Panel Replacement: paso 2, imagen 1 de 3 Nintendo GameCube Front and Back Panel Replacement: paso 2, imagen 2 de 3 Nintendo GameCube Front and Back Panel Replacement: paso 2, imagen 3 de 3

    • With the bottom side of the GameCube facing upward and the screws removed, carefully pull the outer shell of the unit away from the top half.

    • Move the GameCube so that the inside is facing upwards.

    Traducir

  4. Nintendo GameCube Front and Back Panel Replacement, Front and Back Panel: paso 3, imagen 1 de 1

    • Gently press down on the clips located on either side of the the back panel, as shown, and carefully remove it from the main part of the device.

    Traducir

  5. Nintendo GameCube Front and Back Panel Replacement: paso 4, imagen 1 de 1

    • With the back panel removed, carefully unclip the controller ports at the front of the unit.

    • A ribbon cable (outlined in yellow) is still attached to the unit. Do not disconnect this cable.

    • Controller ports are where the controllers plug into the game console, and are a half circular shape.

    Traducir

  6. Nintendo GameCube Front and Back Panel Replacement: paso 5, imagen 1 de 2 Nintendo GameCube Front and Back Panel Replacement: paso 5, imagen 2 de 2

    • Use a Phillips screwdriver to remove the two 2 screws(circled in red) that are located on the back of the control port.

    • Carefully separate the gray outer casing of the control port and the circuit board.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Autor

con 24 otros colaboradores

dcarlin

Miembro Desde 11/05/09

301 Reputación

4 Guías creadas

Insignias: 12

+ 9 más insignias

Equipo

Cal Poly, Team 6-2, Maness Fall 2009 Miembro de Cal Poly, Team 6-2, Maness Fall 2009

CPSU-MANESS-F09S6G2

4 Miembros

44 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 3

Ultimos 7 días: 23

Ultimos 30 días: 132

Todo El Tiempo: 14,242