Esta traducción podría no reflejar los cambios más recientes añadidos a la guía de referencia. Ayúdanos a actualizar la traducción o revisa la guía original.
Introducción
La eliminación de estos paneles permite un mayor acceso a los componentes de GameCube.
Qué necesitas
-
-
Voltea el Gamecube para que la parte inferior quede hacia arriba.
-
Utiliza el destornillador Gamebit de 4,5 mm para quitar los cuatro tornillos.
-
-
-
Con la parte inferior del GameCube mirando hacia arriba y sin los tornillos, tira con cuidado de la cubierta exterior de la unidad para separarla de la mitad superior.
-
Mueve el GameCube para que el interior quede hacia arriba.
This can also be done whilst being in the normal upright position after all 4 of the 4.5mm Gamebit screws have been removed. Pull the top of the shell directly upwards and it should slide off easily.
Less chance of snagging any wires or parts.
-
-
-
-
Presiona suavemente hacia abajo los clips ubicados a ambos lados del panel posterior.
-
Retira con cuidado el panel posterior del GameCube.
A second picture clearly showing which direction to pull the back panel away from the unit would be nice.
-
-
-
Suelta los puertos del controlador en la parte delantera de la unidad.
well... what happens if accidentally i disconnected it?
presumably nothing major. The CMOS battery is attached to the controller ports, so the most i'd expect is that the gamecube loses it's date/time setting. As long as you reset that before jumping into animal crossing or something, you should be fine. I'm currently doing a teardown of my gamecube, and if something does prove to have gone wrong, i'll report back.
sigoshi -
okay, i finished putting it back together. gamecube works fine and surprisingly still remembers what year it is. boots into smash bros and shows memory card contents fine.
sigoshi -
-
-
-
Usa un destornillador Phillips n.° 2 para quitar los dos tornillos en la parte posterior del puerto de control.
-
Separa con cuidado la carcasa exterior gris del puerto de control y la placa de circuito.
must do this?
That step is not needed for the laser replacement.
Love ur labeling and legends. Good on ya
Not a necessary step
-
Para volver a armar tu dispositivo, sigue estas instrucciones en orden inverso.
Para volver a armar tu dispositivo, sigue estas instrucciones en orden inverso.
Cancelar: No complete esta guía.
4 personas más completaron esta guía.
Un agradecimiento especial a estos traductores:
88%
¡ Francisco Javier Saiz Esteban nos está ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›