Introducción

This guide will demonstrate proper removal of the D-Pad. This is necessary in order to clean or replace it.

Partes

No se requieren partes.

Place the controller (buttons down) on a solid surface.
  • Place the controller (buttons down) on a solid surface.

  • Remove the six 9.2mm Tri-wing Y0 screws that hold the back panel in place.

Agregar Comentario

Gently lift the back panel up, separating it from the front panel.
  • Gently lift the back panel up, separating it from the front panel.

  • Some of the buttons may fall out if they are knocked around.

Agregar Comentario

  • Grab the Z-button by the peg with tweezers and lift it out of the controller.

  • During re-assembly, make sure the plastic rim and spring fit into the slot provided, or else the case will not shut.

Agregar Comentario

  • Carefully unhook the cable that is looped around the peg.

Um can soneone explain the peg and cable part? I dont understand it...

Tyler Goamez - Contestar

I would say that the cable is somehow "hooked" to the case and you have to get the cable away from the case so that you can pull out the board

My1 -

  • Lift the circuit board out of the controller.

    • Do not grab the rumble motor to lift the circuit board as shown in the picture. It will in many cases just remove the rumble motor. Instead, grab the edges of the board.

Agregar Comentario

  • Remove the rubber backing with tweezers.

Agregar Comentario

  • Use tweezers to grab the center peg of the directional pad and lift it out of its socket.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Sean Michel

Miembro Desde 14/01/13

1,337 Reputación

14 Guías creadas

Equipo

Cal Poly, Team 19-44, Regan Winter 2013 Miembro de Cal Poly, Team 19-44, Regan Winter 2013

CPSU-REGAN-W13S19G44

4 Miembros

16 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 3

Últimos 7 Días: 14

Últimos 30 Días: 56

Todo El Tiempo: 3,053