Introducción

This guide will show how to replace the Nintendo 64 motherboard.

  1. Remove the expansion pack cover by pushing in the tab and pulling out.
    • Remove the expansion pack cover by pushing in the tab and pulling out.

    Agregar Comentario

  2. If your system uses a jumper pack, the same procedure applies to remove it.
    • If your system uses a jumper pack, the same procedure applies to remove it.

    • A small spoon can be used in place of a spudger.

    • Lever the expansion pack out using a metal spudger.

    Agregar Comentario

    • Remove the six screws on the bottom side indicated in the example with a gamebit head or screwdriver.

    Agregar Comentario

    • Remove the two front feet of the N64.

    Agregar Comentario

    • Rotate to top side up and lift off top cover.

    Agregar Comentario

    • Remove the fourteen screws indicated in the example using the larger Phillips screwdriver.

    I’m not entirely certain if it's a common difference, but my nintendo 64 doesn’t have fourteen screws, but rather, 8 screws, and instead of 3 heat sinks, it only has the one separate heat sink on the chip close to the memory expansion pack. additionally, aside from the 6 screws closest to the expansion pack, the two other screws are held on by nuts under the metal piece.

    Avery Duncan - Contestar

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Remove the metal plate indicated in the example by sliding it back and then lifting it up.

    Agregar Comentario

    • Remove the two screws indicated in the example using the smaller Phillips screwdriver.

    Agregar Comentario

    • Remove the screw to the right of the LED light using the larger Phillips screwdriver.

    Agregar Comentario

    • Remove the small metal bracket from the back of the expansion pack slot.

    Agregar Comentario

    • Remove the small metal bracket from the front of the expansion pack slot with the metal spudger.

    Agregar Comentario

    • Remove the small metal bracket behind the expansion slot using the spudger.

    Agregar Comentario

    • Remove the seven screws indicated in the example using the larger Phillips screwdriver.

    Agregar Comentario

    • Lift off and remove the metal plate as indicated in the example.

    Agregar Comentario

    • Remove the four screws indicated using the #1 Phillips screwdriver.

    Agregar Comentario

    • Lift up and remove the motherboard.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

24 personas más completaron esta guía.

tonymag28

Miembro Desde 28/10/09

1,638 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 5-4, Regan Fall 2009 Miembro de Cal Poly, Team 5-4, Regan Fall 2009

CPSU-REGAN-F09S5G4

7 Miembros

6 Guías creadas

4.2mm doesn't seem right. When I looked to purchase all I saw was 4.5mm and now that I have one in my hand it seems to fit very precisely on the screws on my N64.

negroslim - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 14

Últimos 7 Días: 65

Últimos 30 Días: 228

Todo El Tiempo: 45,249