Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

SD board prerequisite guide.

  1. Remove the two 4.5 mm Phillips screws securing the SD board to the motherboard.
    • Remove the two 4.5 mm Phillips screws securing the SD board to the motherboard.

  2. ABRIR TODAS LAS PESTAÑAS

    Kits de actualización de RAM para Mac

    Compra kits

    Suficiente RAM
    para todas las pestañas

    Compra kits
  3. Use the flat end of a spudger to pry the SD board ribbon cable connector off its socket on the motherboard. Use the flat end of a spudger to pry the SD board ribbon cable connector off its socket on the motherboard.
    • Use the flat end of a spudger to pry the SD board ribbon cable connector off its socket on the motherboard.

  4. Insert the flat end of a spudger between the SD board and the motherboard. Run the spudger along the sides of the SD board to free it from the adhesive pad holding it in place. Once completely freed, lift the SD board straight off the motherboard.
    • Insert the flat end of a spudger between the SD board and the motherboard.

    • Run the spudger along the sides of the SD board to free it from the adhesive pad holding it in place.

    • Once completely freed, lift the SD board straight off the motherboard.

Conclusión

To reassemble your device, follow these instructions in reverse order.

David Hodson

Miembro Desde 13/04/10

140,579 Reputación

127 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 2

Todo El Tiempo: 199