Saltar al contenido principal

Nintendo 3DS Lower Case Replacement

Qué necesitas

  1. Nintendo 3DS Lower Case Replacement, Back Cover: paso 1, imagen 1 de 1
    • Unscrew the four Phillips #00 screws along the top of the back cover.

    • The screws are held in place by locking washers, and will not come out of the back cover.

    • The comments section is full of unlucky souls who will tell you that the screws here through step 4 will strip incredibly easily. Press down fairly hard, and go slow.

  2. Nintendo 3DS Lower Case Replacement: paso 2, imagen 1 de 2 Nintendo 3DS Lower Case Replacement: paso 2, imagen 2 de 2
    • Hold the device in one hand and turn it over.

    • Grab the top edge of the back cover with your opposite hand so that the cover does not fall back into place.

    • Flip the 3DS over again so that the back cover is facing up.

    • Pull the back cover up and away from the rest of the device to remove it.

  3. Nintendo 3DS Lower Case Replacement, Battery: paso 3, imagen 1 de 3 Nintendo 3DS Lower Case Replacement, Battery: paso 3, imagen 2 de 3 Nintendo 3DS Lower Case Replacement, Battery: paso 3, imagen 3 de 3
    • Insert a plastic opening tool into the notch in the lower case above the battery.

    • Pry the battery up with the plastic opening tool.

    • Grab the top edge of the battery and lift it out of the lower case.

  4. Nintendo 3DS Lower Case Replacement, Lower Case: paso 4, imagen 1 de 1
    • Remove the nine 6.3 mm black Phillips screws from the lower case.

    • These screws will strip very easily unless you use the correct size bit. Apply pressure to the screws while turning to avoid stripping them.

    • Remove the 2.4 mm silver Phillips screw above the game cartridge slot.

  5. Nintendo 3DS Lower Case Replacement: paso 5, imagen 1 de 3 Nintendo 3DS Lower Case Replacement: paso 5, imagen 2 de 3 Nintendo 3DS Lower Case Replacement: paso 5, imagen 3 de 3
    • Lift the bottom edge of the lower case off the rest of the 3DS.

    • There are still two ribbon cables connecting the mother board to the case, so be sure not to pull the lower case all the way off.

    • Use a plastic opening tool to pry the shoulder button ribbon cables off their sockets on the motherboard.

    • Remove the lower case from the device.

Conclusión

To reassemble your device, follow these instructions in reverse order.

7 personas más completaron esta guía.

David Hodson

Miembro Desde 04/13/10

150,352 Reputación

127 Guías creadas

2 comentarios

Is this guide for the original 3ds?

Glenn Racz - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 21

Ultimos 30 días: 101

Todo El Tiempo: 15,585