Repara tus cosas Comunidad Tienda

Ninja Professional BL610 LED Replacement

Introducción

Use this guide to replace the LED on the circuit board of your device.

Qué necesitas

  1. Ninja Professional BL610 LED Replacement, LED: paso 1, imagen 1 de 1

    • Remove six screws (12mm long, 6mm head diameter) from bottom of the blender using a Phillips #2 screwdriver.

    Traducir

  2. Ninja Professional BL610 LED Replacement: paso 2, imagen 1 de 1

    • Remove six screws (12mm long, 6mm head diameter) from component housing using Phillips #2 screwdriver.

    Traducir

  4. Ninja Professional BL610 LED Replacement: paso 3, imagen 1 de 1

    • Remove five screws from circuit board using Phillips #2 screwdriver.

    Traducir

  5. Ninja Professional BL610 LED Replacement: paso 4, imagen 1 de 1

    • Once the screws are removed, lift the circuit board to access the back.

    Traducir

  6. Ninja Professional BL610 LED Replacement: paso 5, imagen 1 de 1

    • Locate the LED you wish to replace and note its position on the opposite side of the circuit board.

    Traducir

  7. Ninja Professional BL610 LED Replacement: paso 6, imagen 1 de 1

    • Desolder both of the LED leads and remove the LED light. Note the orientation of LED, this is important for replacing the LED. The Replacement LED needs to be soldered in the same orientation.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 1 otro colaborador

Rosniel Castro

Miembro Desde 09/27/17

482 Reputación

4 Guías creadas

Insignias: 8

+ 5 más insignias

Equipo

USF Tampa, Team S14-G3, Boczar Fall 2017 Miembro de USF Tampa, Team S14-G3, Boczar Fall 2017

USFT-BOCZAR-F17S14G3

4 Miembros

4 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 4

Todo El Tiempo: 140