Saltar al contenido principal

Ninja NJ600 Fan Replacement

Qué necesitas

  1. Ninja NJ600 Fan Replacement, Blender Base Cover: paso 1, imagen 1 de 2 Ninja NJ600 Fan Replacement, Blender Base Cover: paso 1, imagen 2 de 2
    • Remove the five screws (13mm long, 6mm head diameter) using a Phillips #2 screwdriver.

  2. Ninja NJ600 Fan Replacement: paso 2, imagen 1 de 2 Ninja NJ600 Fan Replacement: paso 2, imagen 2 de 2
    • Without removing any screws, you can pull the 2nd layer free from the base. Do this now and set it down gently next to the base.

    • The power cord runs through a hole in the side of this layer. Squeeze the cord and pull it through the hole to separate the layer from the cord.

  3. Ninja NJ600 Fan Replacement: paso 3, imagen 1 de 3 Ninja NJ600 Fan Replacement: paso 3, imagen 2 de 3 Ninja NJ600 Fan Replacement: paso 3, imagen 3 de 3
    • Using the Phillips #2 screwdriver, remove these six screws (13mm long, 6mm head diameter). Then carefully remove this layer, and rest it next to the blender base.

    • Be careful not to damage the two wires that are keeping this third layer attached to the base.

  4. Ninja NJ600 Fan Replacement, Fan: paso 4, imagen 1 de 1
    • Hold the fan steady and use a wrench or pliers to remove the nut in the image.

    • The fan is sharp. Use caution when handling with bare hands.

    • A towel or gloves may be useful when holding the fan for this step.

  5. Ninja NJ600 Fan Replacement: paso 5, imagen 1 de 1
    • Hold the fan and use the flathead 4.0 screwdriver to loosen the washer.

    • The fan is sharp, use caution when handling with bare hands.

    • You may use a towel or gloves to avoid handling the fan with your bare hands.

  6. Ninja NJ600 Fan Replacement: paso 6, imagen 1 de 2 Ninja NJ600 Fan Replacement: paso 6, imagen 2 de 2
    • Slide the washer and fan off of the screw.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Ryan Heller

Miembro Desde 04/01/15

107 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 24-2, Lancaster Spring 2015 Miembro de Cal Poly, Team 24-2, Lancaster Spring 2015

CPSU-LANCASTER-S15S24G2

4 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 4

Ultimos 30 días: 10

Todo El Tiempo: 1,326