Introducción

If there is a power problem, you may need to reattach wires to the battery compartment or replace it completely. If the problem is Corrosion, just see the guide on corrosion.

  • In this guide we will be referring to 'left' and 'right' as though the camera's front (the part that says Nikon) is facing you.

  • Unscrew the large metal screw on the left side using a quarter and remove the battery cover.(Picture not available)

Agregar Comentario

Use a 00 Phillips head screwdriver to remove the small screw on the far left of the battery compartment.
  • Use a 00 Phillips head screwdriver to remove the small screw on the far left of the battery compartment.

Agregar Comentario

  • Pull up on the tab to remove the batteries.

  • Note: The batteries will probably fall out of their holder.

Agregar Comentario

  • Use a 00 Phillips head screwdriver to remove the four screws from inside the case.

Agregar Comentario

  • Remove the battery compartment from the camera.

  • Note: On some models, the compartment is soldered in by the wires shown. If so you will need to desolder them.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Equipo

Cal Poly, Team 25-26, Garner Spring 2011 Miembro de Cal Poly, Team 25-26, Garner Spring 2011

CPSU-GARNER-S11S25G26

3 Miembros

6 Guías creadas

Hey, i lost the bracket… do u guys have any idea where could i get one?

David mate - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 3

Últimos 7 Días: 19

Últimos 30 Días: 86

Todo El Tiempo: 9,580