Saltar al contenido principal

Introducción

Replacing the board holding the GPS, DC in and AV out connectors.

Replacement of the electronic card including the GPS connector, DC IN, and AV out.

Partes

No se especificaron partes.

  1. Remove the three screw in red
    • Remove the three screw in red

    • Remove the three long screw in orange

    • Remove the screw in yellow

    • Use a little of WD40 if the screw is blocked

  2. Remove the 4 screw in green Remove the 2 screw in yellow Remove the 2 screw in yellow
    • Remove the 4 screw in green

    • Remove the 2 screw in yellow

  3. Slacken the grip side of the cover first Remove the cover wholly. Be carefull with the two flex cables
    • Slacken the grip side of the cover first

    • Remove the cover wholly.

    • Be carefull with the two flex cables

  4. Disconnect the FPC of the back cover Toggle up the black plate to free the flex cable Remove the grip cover by rotating
    • Disconnect the FPC of the back cover

    • Toggle up the black plate to free the flex cable

    • Remove the grip cover by rotating

  5. Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now

    Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now
  6. Toggle up the black plate and disconnect the flex cable Toggle up the white plate and disconnect the flex cable Push up the right slide of the connector to free it
    • Toggle up the black plate and disconnect the flex cable

    • Toggle up the white plate and disconnect the flex cable

    • Push up the right slide of the connector to free it

  7. Push up the bottom of the connector to free it
    • Push up the bottom of the connector to free it

  8. Remove the six screws to free the protection plate Disconnect the white cables Disconnect the microphone Cable
    • Remove the six screws to free the protection plate

    • Disconnect the white cables

    • Disconnect the microphone Cable

  9. Disconnect the speaker cable Remove the two screws to free the PCB Toggle th PCB from Left to Right
    • Disconnect the speaker cable

    • Remove the two screws to free the PCB

    • Toggle th PCB from Left to Right

  10. Disconnect the black cables
    • Disconnect the black cables

  11. Remove the two screws Push the IF/SB PCB
    • Remove the two screws

    • Push the IF/SB PCB

    • Unsolder the 3 Wires ( Red, Black, Orange )

Conclusión

To reassemble your device, follow the instructions in reverse order.

Un agradecimiento especial a estos traductores:

100%

Estos traductores nos están ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›

JOLY

Miembro Desde 06/03/16

182 Reputación

1 Guía escrita

Equipo

Nexurium - Bastien JOLY Miembro de Nexurium - Bastien JOLY

Business

1 Miembro

2 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 8

Últimos 30 Días: 36

Todo El Tiempo: 785