Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently pry and lift the left motherboard shield off.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove one 3.5 mm J000 screw securing the right motherboard shield.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently lift the right motherboard shield off with the tip of a spudger.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully disconnect the red connector with tweezers.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove four 3.5 mm J000 screws securing the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently pull the port side cover away from the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove four 6 mm J000 screws securing the tripod plate.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully lift the tripod plate from the backside of the camera and slide out the grounding clip from under the lens mount.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.