Repara tus cosas Comunidad Tienda

Nikon D7000 Image Sensor Replacement

Introducción

Use this guide to replace the image sensor.

Qué necesitas

  1. Nikon D7000 Image Sensor Replacement, Motherboard: paso 1, imagen 1 de 1

    • Remove the following 5 screws securing the bottom cover to the camera body:

    • Four 6 mm J000 screws.

    • One 8 mm J000 screw (under lens mount).

    Traducir

  2. Nikon D7000 Image Sensor Replacement: paso 2, imagen 1 de 1

    • Remove three 6 mm J000 screws from under the battery cover.

    Traducir

  3. Nikon D7000 Image Sensor Replacement: paso 3, imagen 1 de 2 Nikon D7000 Image Sensor Replacement: paso 3, imagen 2 de 2

    • Gently pull the bottom cover off of the camera body.

    Traducir

  4. Nikon D7000 Image Sensor Replacement: paso 4, imagen 1 de 1

    • Remove the following screws from the port area:

    • Two 3.5 mm J000 screws.

    • One 6 mm J000 screw (right above ports).

    Traducir

  5. Nikon D7000 Image Sensor Replacement: paso 5, imagen 1 de 1

    • Peel the rear rubber piece off with tweezers.

    Traducir

    This is not needed : if you don't touch this rubber & screw the SD card cover will come off at the same time that the back case.


    = Quicker and easier

    Xavier - Contestar

  6. Nikon D7000 Image Sensor Replacement: paso 6, imagen 1 de 1

    • Remove one 4.25 mm J000 screw from behind the rear rubber piece.

    Traducir

    This is not needed : if you don't touch this rubber & screw the SD card cover will come off at the same time that the back case.


    = Quicker and easier

    Xavier - Contestar

  7. Nikon D7000 Image Sensor Replacement: paso 7, imagen 1 de 1

    • Pull the eyepiece cover up to remove it.

    Traducir

  8. Nikon D7000 Image Sensor Replacement: paso 8, imagen 1 de 1

    • Remove two 6 mm J000 screws from behind the eyepiece cover.

    • On D7100 models, there is an additional screw holding the back plate on. This screw is located in the diopter (dial with + - on it). This screw can be accessed by peeling up this sticker on the diopter.

    Traducir

    Concerning the diopter, it's wrong : D7000 also have a screw in it.


    See step 41.

    Xavier - Contestar

  9. Nikon D7000 Image Sensor Replacement: paso 9, imagen 1 de 1

    • Open the SD card cover by pushing slightly down with your thumb and sliding up.

    Traducir

  11. Nikon D7000 Image Sensor Replacement: paso 10, imagen 1 de 1

    • Remove four 6 mm J000 screws that secure the SD card cover.

    Traducir

  12. Nikon D7000 Image Sensor Replacement: paso 11, imagen 1 de 1

    • Gently pull the SD card cover off.

    Traducir

    Attention! High voltage. After removing the memory card cover, remove the yellow sticker and use a 220 volt 15 watt incandescent lamp to discharge the capacitor.

    Rust Twentyone - Contestar

  13. Nikon D7000 Image Sensor Replacement: paso 12, imagen 1 de 1

    • Remove the following screws that secure the back case:

    • One 6 mm J000 screw.

    • One 3 mm J000 screw.

    Traducir

  14. Nikon D7000 Image Sensor Replacement: paso 13, imagen 1 de 1

    • Carefully lift the back case off.

    Traducir

  15. Nikon D7000 Image Sensor Replacement: paso 14, imagen 1 de 3 Nikon D7000 Image Sensor Replacement: paso 14, imagen 2 de 3 Nikon D7000 Image Sensor Replacement: paso 14, imagen 3 de 3

    • Disconnect the following two ribbon cables from the motherboard.

    • See our Cable Connector Guide for help with ribbon cable connectors!

    Traducir

  16. Nikon D7000 Image Sensor Replacement: paso 15, imagen 1 de 2 Nikon D7000 Image Sensor Replacement: paso 15, imagen 2 de 2

    • Remove the following screws securing the left motherboard shield:

    • One 2 mm J000 screw (on the bottom).

    • One 3.5 mm J000 screw (on the back).

    • Be careful of the grounding clips on the motherboard.

    Traducir

  17. Nikon D7000 Image Sensor Replacement: paso 16, imagen 1 de 1

    • Gently pry and lift the left motherboard shield off.

    Traducir

    No need to remove shield. Risk of damaging clips holding shield.

    Ziyang - Contestar

  18. Nikon D7000 Image Sensor Replacement: paso 17, imagen 1 de 1

    • Remove one 3.5 mm J000 screw securing the right motherboard shield.

    Traducir

    No need to remove shield. Risk of damaging clips holding shield.

    Ziyang - Contestar

  19. Nikon D7000 Image Sensor Replacement: paso 18, imagen 1 de 1

    • Gently lift the right motherboard shield off with the tip of a spudger.

    Traducir

  20. Nikon D7000 Image Sensor Replacement: paso 19, imagen 1 de 3 Nikon D7000 Image Sensor Replacement: paso 19, imagen 2 de 3 Nikon D7000 Image Sensor Replacement: paso 19, imagen 3 de 3

    • Disconnect remaining ribbon cables.

    Traducir

  21. Nikon D7000 Image Sensor Replacement: paso 20, imagen 1 de 2 Nikon D7000 Image Sensor Replacement: paso 20, imagen 2 de 2

    • Disconnect remaining ribbon cables.

    Traducir

    One more ribbon behind press down tab

    Ziyang - Contestar

  22. Nikon D7000 Image Sensor Replacement: paso 21, imagen 1 de 1

    • Carefully disconnect the red connector with tweezers.

    Traducir

  23. Nikon D7000 Image Sensor Replacement: paso 22, imagen 1 de 1

    • Remove four 3.5 mm J000 screws securing the motherboard.

    Traducir

  24. Nikon D7000 Image Sensor Replacement: paso 23, imagen 1 de 1

    • Gently pull the port side cover away from the motherboard.

    Traducir

  25. Nikon D7000 Image Sensor Replacement: paso 24, imagen 1 de 1

    • Lift the motherboard off.

    Traducir

  26. Nikon D7000 Image Sensor Replacement, Image Sensor: paso 25, imagen 1 de 2 Nikon D7000 Image Sensor Replacement, Image Sensor: paso 25, imagen 2 de 2

    • Disconnect black and white speaker cable.

    Traducir

  27. Nikon D7000 Image Sensor Replacement: paso 26, imagen 1 de 1

    • Remove three 6 mm J000 screws securing the image sensor.

    Traducir

    Best to set markings on the three screws before removing sensor. To preserve alignment of sensor and body frame

    Ziyang - Contestar

    This step is NOT necessary if you don't plan on doing anything with the sensor itself

    -> just let it all attached together and save yourself time and energy

    Xavier - Contestar

  28. Nikon D7000 Image Sensor Replacement: paso 27, imagen 1 de 1

    • Carefully lift the image sensor plate out of the camera.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

19 personas más completaron esta guía.

Autor

con 2 otros colaboradores

Jed Chen

Miembro Desde 04/01/15

1,796 Reputación

3 Guías creadas

Insignias: 16

+ 13 más insignias

Equipo

Cal Poly, Team 24-6, Lancaster Spring 2015 Miembro de Cal Poly, Team 24-6, Lancaster Spring 2015

CPSU-LANCASTER-S15S24G6

3 Miembros

5 Guías creadas

4 comentarios

I really need to do this operation! One question: I’m shopping for a replacement sensor and in the photos it looks like the cables off the sensor assembly are free hanging. In this tutorial there is only the disconnection of the black and white speaker cables. Where do these cables go?

Sean McDonald - Contestar

I am grateful for this! Thanks - it worked a treat!

Peter Davies - Contestar

Thanks, I have done it with the Nikon d7200, it is different I have made some comments already, similar to the Nikon d7100 you have to unscrew the diopter and has 2 screws under the rubber what you have to remove… The motherboard is totally different

Rudi Zimmerer - Contestar

Any suggestions for locating a reputable, OEM part? Tons of choices on eBay with widely varying prices. Hints or clues to ensure I am buying authentic and safe parts are appreciated! Thanks!

George Peters - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 11

Ultimos 30 días: 44

Todo El Tiempo: 10,255