Saltar al contenido principal

Introducción

Removing the battery door makes it easier to clean up after a battery leak or unscrew the bottom panel. It is also necessary for the installation of certain accessories.

  1. On the bottom of the camera, pull the release tab towards the center of the camera, then pull up. On the bottom of the camera, pull the release tab towards the center of the camera, then pull up.
    • On the bottom of the camera, pull the release tab towards the center of the camera, then pull up.

  2. Grip and hold the front end of the battery door at a 45-degree angle from the case. Pop the battery door out by pulling the front tab up.
    • Grip and hold the front end of the battery door at a 45-degree angle from the case.

    • Pop the battery door out by pulling the front tab up.

    • When reassembling, seat the rear tab in its slot before pushing the front tab back in.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Jacob Rardin

Miembro Desde 14/04/14

1,294 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 13-28, Maness Spring 2014 Miembro de Cal Poly, Team 13-28, Maness Spring 2014

CPSU-MANESS-S14S13G28

4 Miembros

6 Guías creadas

My problem is the door on my Nikon D850 broke, leaving the small part with the two prongs in place, and I don’t know how to get them out to install a replacement door. Would appreciate suggestions tootswaller22@gmail.com

Harry Langdon - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 19

Todo El Tiempo: 2,396