Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two visible 6.0 mm Philips #0 screws on the left and right sides of the viewfinder. These screws are highlighted in red.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four 6.0 mm Philips #0 screws on the left and right sides of the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four highlighted 3.0 mm Philips #0 screws on the bottom of the camera.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
While pulling the bottom down, remove the back of the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
You will be able to see the ribbon cables coming out from the back panel, disconnect the cables.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Slowly push the upper body up until you see the frame of the viewfinder
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a spudger to keep the upper body separate from the printed circuit board.
-
Wiggle the plastic eyepiece out of the frame. This may require some force.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the viewfinder with the plastic opening tool.
-
Cancelar: No complete esta guía.
2 personas más completaron esta guía.