Introducción

This guide will walk you through the necessary steps to remove the back panel of the Nikon Coolpix E5700.

Partes

No se requieren partes.

Use your finger tip to slide the battery release tab toward the battery symbol on the E5700.
  • Use your finger tip to slide the battery release tab toward the battery symbol on the E5700.

  • Open the battery door.

Agregar Comentario

Pull the battery out of the E5700.
  • Pull the battery out of the E5700.

  • It may be necessary to wiggle the battery while pulling to free it from its pocket in the case.

Agregar Comentario

  • Turn to the bottom of the camera.

  • Remove the two Phillips screws located directly below the back monitor

Agregar Comentario

  • Turn the camera to the side with the memory card slot and open the compartment for the CF card.

  • Remove the top two Phillips screws closest to the back panel.

Agregar Comentario

  • Turn to the back of the camera.

  • Remove the top most Phillips screw on the back panel.

Agregar Comentario

  • Turn to the last side of the back panel.

  • Remove the Phillips screw below the eyepiece.

  • Remove the Phillips screw located above the speaker.

Agregar Comentario

  • Gently begin to remove the back panel.

    • Caution: There are two bundles of wires connecting the back panel to the camera. Be sure not to pull too hard and yank these out.

Before pulling the panel. You MUST remove first de rubber bumper ( arrond the ocular piece ).

diego - Contestar

  • Now gently unplug the two wires at the bottom of the panel.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Raana

Miembro Desde 12/04/11

57 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 24-58, Amido Spring 2011 Miembro de Cal Poly, Team 24-58, Amido Spring 2011

CPSU-AMIDO-S11S24G58

4 Miembros

9 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 5

Todo El Tiempo: 1,686