Nikon Coolpix 5400 Back Cover Replacement

Introducción

This guide will walk you through how to remove the back case of the Nikon Coolpix 5400. The processes only requires a handful of screws to be removed and a few connecting wires. When removing the wire connectors, be careful not to break the plastic fittings.

Qué necesitas

Paso 1 Back Cover

Nikon Coolpix 5400 Back Cover Replacement, Back Cover: paso 1, imagen 1 de 1

Remove one 3.0mm Phillips #0 screw from the top of the case.

Editar

Paso 2

Remove two 3.0mm Phillips #0 screws from the card reader side of the case.

Editar

Paso 3

Remove four 3.0mm Phillips #0 screws from the bottom of the camera.

Editar

Paso 4

Remove one 3.0mm Phillips #0 screw from the side of the camera.

Editar

Paso 5

Use a plastic opening tool to gently remove the back case from the rest of the camera.

Editar

Paso 6

Pull the back of the camera cover apart.
Connecting wires that are still attached to the back cover are fragile.

Editar

Paso 7

Remove the two 4.0mm Phillips #0 screws holding the circuit board to the back case.

Editar

Paso 8

Pull the LCD screen cables in the direction that the wires are exiting the circuit board.
Pull the wire connector gently, the plastic is very fragile.

Editar

Paso 9

Pull the toggle wheel wire connector up and away from the top of the camera.
Pull the button control panel wire connector up and away from the top of the camera.
Gently remove the wire connectors; the plastic is fragile.