Repara tus cosas Comunidad Tienda

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Nikon Coolpix 3500 front cover Replacement.

Introducción

Replacing the front cover of a Nikon Coolpix 3500.

Qué necesitas

  1. Nikon Coolpix 3500 front cover Replacement., Battery: paso 1, imagen 1 de 1

    • Unlatch the battery cover and slide the cover out. Place cover to the side, it will not be needed for the next few steps.

    • Remove the battery.

    • Remove the battery cover without using excessive force. Keep in mind this cover is fragile.

    Traducir

  2. Nikon Coolpix 3500 front cover Replacement., Front Cover: paso 2, imagen 1 de 1

    • Remove the two 4.5 mm screws that sit next to the battery slot.

    • Remove the 3 mm screw that sits below the CF card slot.

    • Remove the 4.5 mm screw that sits above the digital I/O cover.

    Traducir

  3. Nikon Coolpix 3500 front cover Replacement.: paso 3, imagen 1 de 1

    • Remove the two 4.5 mm screws that sit inside the battery slot.

    Traducir

  5. Nikon Coolpix 3500 front cover Replacement.: paso 4, imagen 1 de 1

    • Remove the two 5 mm screws that sit near the camera strap eyelet.

    • Remove the camera strap eyelet.

    Traducir

  6. Nikon Coolpix 3500 front cover Replacement.: paso 5, imagen 1 de 1

    • Remove the 5 mm screw and cap that were underneath the camera strap eyelet.

    Traducir

  7. Nikon Coolpix 3500 front cover Replacement.: paso 6, imagen 1 de 2 Nikon Coolpix 3500 front cover Replacement.: paso 6, imagen 2 de 2

    • Remove the five 3.5 mm screws that sit at the bottom of the camera.

    • Remove the grey plastic piece, which the five screws held in place, by gently detaching the front cover.

    • Do not apply too much force; two wires still connect the front cover to the logic board.

    Traducir

  8. Nikon Coolpix 3500 front cover Replacement.: paso 7, imagen 1 de 2 Nikon Coolpix 3500 front cover Replacement.: paso 7, imagen 2 de 2

    • Using a spudger, detach the white-capped wire.

    • Using a spudger, detach the orange-capped wire and set the front cover aside.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 5 otros colaboradores

richard guenther

Miembro Desde 04/19/10

183 Reputación

6 Guías creadas

Insignias: 6

+ 3 más insignias

Equipo

Cal Poly, Team 30-38, Garner Spring 2010 Miembro de Cal Poly, Team 30-38, Garner Spring 2010

CPSU-GARNER-S10S30G38

5 Miembros

11 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 1,887