Introducción

This guide is to be used to install the battery in the case that the battery dies or no longer functions properly. A Phillips screwdriver will be needed to complete this installation.

Herramientas

No se requieren herramientas.

Partes

  1. Using the thumb, firmly push the SD/Battery cover in the middle and then in the direction of the arrow on the SD/Battery cover.
    • Using the thumb, firmly push the SD/Battery cover in the middle and then in the direction of the arrow on the SD/Battery cover.

      • This will cause the SD/Battery cover to pop open.

  2. Press orange clip to eject battery (battery not shown).
    • Press orange clip to eject battery (battery not shown).

  3. ¡Envío gratuito para todos los pedidos de más de USD100.00 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda
  4. While cupping hand under the bottom of the SD/Battery slot, turn the camera upright.
    • While cupping hand under the bottom of the SD/Battery slot, turn the camera upright.

      • This will cause the battery to fall into the hand (battery not shown).

  5. Following the positive and negative placement signs, slide the new battery into the battery slot (battery not shown).
    • Following the positive and negative placement signs, slide the new battery into the battery slot (battery not shown).

  6. Slide the SD/Battery cover in the reverse direction of the arrow on the SD/Battery cover until it clicks into place.
    • Slide the SD/Battery cover in the reverse direction of the arrow on the SD/Battery cover until it clicks into place.

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Equipo

Clemson, Team 12-5, Benson Spring 2013 Miembro de Clemson, Team 12-5, Benson Spring 2013

CLEM-BENSON-S13S12G5

4 Miembros

7 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 2

Todo El Tiempo: 373