1. Remove the screw located near the speaker port using a Phillips 00 screwdriver.
    • Remove the screw located near the speaker port using a Phillips 00 screwdriver.

    Agregar Comentario

  2. Turn camera upside down so that the battery compartment is facing you.
    • Turn camera upside down so that the battery compartment is facing you.

    • Remove all four screws from the bottom of the camera with a Phillips 00 screwdriver.

    Agregar Comentario

    • Rotate the camera to the opposite side where the A/V outlet is located.

    • Unscrew and remove all four screws with a Phillips 00 screwdriver.

    Agregar Comentario

    • Turn the camera so that the Wi-Fi adapter is facing you.

    • Unscrew and remove all four screws with a Phillips 00 screwdriver.

    Agregar Comentario

    • Using a plastic opening tool, pry the front casing of the camera.

    • Continue this motion all around the front casing of the camera.

    • Gently pull apart the front casing from the rest of the camera.

    Agregar Comentario

    • Using the plastic opening tool pry the back casing of the camera.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Orange ribbon is fragile

    • Carefully pull apart the back casing of the camera from the front of the camera without tearing the orange ribbon.

    Agregar Comentario

    • Pull down the on the black latch to carefully separate the orange ribbon from the motherboard.

    • Pull apart the orange ribbon and front casing from the rest of the camera.

    Agregar Comentario

    • Use plastic opening tool to carefully pry the LCD Screen from the camera.

    Agregar Comentario

    • Gently pull the ribbon cable down to release the latch, then pull up to remove it from the motherboard.

    Agregar Comentario

  4. Agregar Comentario

    • Continue by removing two screws from the back of the camera body.

    Agregar Comentario

    • Remove the screw connecting the wifi card cover to the front of the camera.

    Agregar Comentario

    • Remove the final screw connecting the Wifi card cover to the case.

    Agregar Comentario

    • Gently pull the Wifi card cover off of the camera body.

    Agregar Comentario

    • Remove the screw holding the Wifi Card to the camera body.

    Agregar Comentario

    • Gently pull the WiFi card out of the camera.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Joshua Avery

Miembro Desde 23/01/12

19 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 3-28, Amido Winter 2012 Miembro de Cal Poly, Team 3-28, Amido Winter 2012

CPSU-AMIDO-W12S3G28

4 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 3

Todo El Tiempo: 765