Introducción

Replace your worn out inner dome daughterboard: which contains Atmel ATMEGA328P, NXP Semiconductors 44501 Near-Field Communications Controller, TXC 8.00 MHz Crystal Quartz Oscillator, YF04E, and the status LED.

  1. Squeeze and pull to pop the cap off of the Nexus Q.
    • Squeeze and pull to pop the cap off of the Nexus Q.

  2. Disconnect the taoglas Wi-Fi Dual Band Antenna by prying with a spudger. Once the antenna is disconnected, simply pull it off the outside of the inner dome.
    • Disconnect the taoglas Wi-Fi Dual Band Antenna by prying with a spudger.

    • Once the antenna is disconnected, simply pull it off the outside of the inner dome.

  3. ¡Envío gratuito para todos los pedidos de más de USD100 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda
  4. Undo the ZIF connector by prying with a spudger.
    • Undo the ZIF connector by prying with a spudger.

  5. Use a T10 Torx screwdriver to remove the four 1.3 mm screws holding the inner dome in place.
    • Use a T10 Torx screwdriver to remove the four 1.3 mm screws holding the inner dome in place.

  6. Use a T6 Torx screwdriver to undo the three 0.8 mm screws holding the inner dome daughterboard in place.
    • Use a T6 Torx screwdriver to undo the three 0.8 mm screws holding the inner dome daughterboard in place.

  7. Use a spudger to disconnect the daughterboard from the ZIF connector.
    • Use a spudger to disconnect the daughterboard from the ZIF connector.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Alex Thomas

Miembro Desde 31/01/13

27 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 7-10, Maness Winter 2013 Miembro de Cal Poly, Team 7-10, Maness Winter 2013

CPSU-MANESS-W13S7G10

4 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 6

Todo El Tiempo: 810