Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a plastic opening tool, remove the thin plastic cover from back of the tablet by prying up from its small tab.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the five 2mm screws on the back of the device using a PH00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pry the device apart by inserting a plastic opening tool in the seam between the plastic backing and display assembly. Use the tool to unclip the plastic tabs in between the backing and the display.
-
Pull the the plastic backing off the display assembly using your hands.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Detach the three connector ribbons passing over the battery using the plastic opening tool.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the twelve 2mm screws around the perimeter of the battery with a PH00 screwdriver.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the battery by lifting it upward and pulling it away from the connector.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove one screw on the logic board with a PH00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect right speaker connector ribbon from logic board.
-
Lift the speaker out by pulling up on its corner.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect connectors around the perimeter of the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove motherboard by gently pulling upward under its corner.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three 2mm screws along the right side of the device using a PH00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unseat the small vibrator motor by gently applying upward pressure with a spudger.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the assembly by gently applying upward pressure with the spudger on the assembly.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently pull battery-audio jack-USB assembly upward, detaching it from its adhesive.
-