Nerf N-Strike Elite Rough Cut 2x4 Springs Replacement

Introducción

This guide will show you how to replace the springs in a Nerf N-Strike Elite Rough Cut 2x4 gun. Nerf guns use springs to power their guns. However, over time, these springs lose power and thus the gun cannot shoot as far or as powerfully. When this happens, the gun can simply not be effective for Nerf fights. However instead of buying a new gun and throwing away the old one you can simply add new springs and get the same if not better performance.

Qué necesitas

Paso 1 Springs

Nerf N-Strike Elite Rough Cut 2x4 Springs Replacement, Springs: paso 1, imagen 1 de 2

Nerf N-Strike Elite Rough Cut 2x4 Springs Replacement, Springs: paso 1, imagen 2 de 2

Remove three screws with a Phillips #1 screwdriver.
Remove the pump grip.

Editar

Paso 2

Remove thirteen highlighted screws using a Phillips #1 screwdriver.
The top rail has shorter screws than the rest.
Some of these are captive screws and cannot be removed.

Editar

Paso 3

Nerf N-Strike Elite Rough Cut 2x4 Springs Replacement: paso 3, imagen 3 de 3

Remove the backside by sliding the plastic spudger across the seam.
There are loose parts that can fall out. Take these off and put them aside.

Editar

Paso 4

Nerf N-Strike Elite Rough Cut 2x4 Springs Replacement: paso 4, imagen 3 de 3

Separate the trigger mechanism from the barrel.

Editar

Paso 5

Nerf N-Strike Elite Rough Cut 2x4 Springs Replacement: paso 5, imagen 3 de 3

Remove the plunger springs from the mechanism by pulling one of the springs back then bending it off the connection.
These are tricky to remove, so be careful when pulling them off.

Editar