Introducción

Keypad installation can be used to replace a worn keypad or a keypad that is misaligned.

Partes

No se requieren partes.

Place thumb on the rubber tab on the lower back of the phone.
  • Place thumb on the rubber tab on the lower back of the phone.

  • Push away from the phone to release back panel.

Agregar Comentario

Lift the back panel of the phone to expose battery (not shown here).
  • Lift the back panel of the phone to expose battery (not shown here).

Agregar Comentario

  • Pull the antenna up to reveal two of the six screws.

Agregar Comentario

  • Unscrew all six screws on the back side of the phone using a T-6 bit.

Agregar Comentario

  • Gently separate the front and back sides of the phone, as shown in the picture.

  • Be careful not to break or bend the ribbon cables.

Agregar Comentario

  • Detach the first ribbon cable by unplugging it from the motherboard.

Agregar Comentario

  • Detach the speaker ribbon cable from the motherboard.

Agregar Comentario

  • Remove the motherboard from the front half of the phone by gently shaking it loose. It should come out with little to no trouble.

Agregar Comentario

  • Push lightly from the front of the keypad to remove it.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Haley S

Miembro Desde 11/03/13

1 Reputación

4 Guías creadas

Equipo

Clemson, Team 13-6, Benson Spring 2013 Miembro de Clemson, Team 13-6, Benson Spring 2013

CLEM-BENSON-S13S13G6

3 Miembros

10 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 88