Qué necesitas
-
-
Pick up the cell phone with the back facing towards you.
-
Push down on the silver tab located at the top center of the back of the Motorola W490 cellphone.
-
While pushing down on the silver tab, slide the back cover towards the silver tab. Remove the back cover.
-
-
-
Remove the battery by pulling the battery from the top corners labeled "Pull Here" located on either side of the top of the battery.
-
Set the battery aside.
-
-
-
After taking out the battery, locate four star-shaped 5.4 mm T6 screws on top and middle of the rear of the phone. Indicated by the red circles.
-
Remove all the screws using the Torx T6 Screwdriver.
-
-
-
-
Identify the flex cable attachment. Indicated in a red square.
-
Detach the bottom half of the flex cable, pop it off of the circuit board.
-
Pick up the loosened circuit board from the phone and set aside.
-
-
-
Use the blue plastic opening tool to pry off all four of the rubber stickers from the upper inside face.
-
Use the Torx T5 screwdriver to remove the four 5.4 mm screws from the upper inner face.
-
-
-
Remove the other end of the flex cable from the LCD board.
-
Pull the cable through the phone casing hinge and remove it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Equipo
Clemson, Team 14-1, Benson Fall 2012 Miembro de Clemson, Team 14-1, Benson Fall 2012
CLEM-BENSON-F12S14G1
4 Miembros
23 Guías creadas
2 comentarios
How the !@#$ do you get the new flex cable in??? Id about anybody else, but mine was snapped in half when I opened it, thus, I was unable to see the original assembly... HELP???? Please??
