Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using your finger, press down on the clip holding the back cover on.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the spudger or your finger, gently pull the battery out from the top.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four rubber pieces from the face of the phone using the sharp end of the spudger.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four Torx-6 screws from underneath the rubber pieces.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Close the phone before proceeding.
-
Using the flat end of the spudger, insert it under the plastic at the top left of the phone.
-
Gently, although a small amount of force is required, use a twisting motion to pull the plastic casing away from the body of the phone.
-
Continue to move around the phone counter clockwise until the casing is separated from the body.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
If the casing has not popped off of the body, remove it carefully from the the phone.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After completing Steps 3-6 in the casing repair guide, your phone should look like this.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the spudger to unhinge the four clips around the metal casing of the top logic board.
-
Gently take off the metal casing of the logic board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use spudger to gently disconnect the ribbon cable from phone.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Ignoring the top logic board, take the phone in your hand and turn your attention towards the speaker.
-
-
Este paso está sin traducir. Ayuda a traducirlo
Herramienta utilizada en este paso:Tweezers$4.99-
Place the spudger between the speaker and the clip shown.
-
Separate the clip from the speaker while lifting on the speaker.
-
The speaker should separate. Use the tweezers to grab the speaker.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.