Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Motorola W385 Top Logic Board Replacement

Qué necesitas

  1. Motorola W385 Top Logic Board Replacement, Battery: paso 1, imagen 1 de 1
    • Using your finger, press down on the clip holding the back cover on.

  2. Motorola W385 Top Logic Board Replacement: paso 2, imagen 1 de 1
    • Using the spudger or your finger, gently pull the battery out from the top.

  3. Motorola W385 Top Logic Board Replacement, Front Casing: paso 3, imagen 1 de 1
    • Remove the four rubber pieces from the face of the phone using the sharp end of the spudger.

    • The rubber pieces are held in with a mild adhesive.

  4. Motorola W385 Top Logic Board Replacement: paso 4, imagen 1 de 1
    • Remove the four Torx-6 screws from underneath the rubber pieces.

  5. Motorola W385 Top Logic Board Replacement: paso 5, imagen 1 de 2 Motorola W385 Top Logic Board Replacement: paso 5, imagen 2 de 2
    • Close the phone before proceeding.

    • Using the flat end of the spudger, insert it under the plastic at the top left of the phone.

    • Gently, although a small amount of force is required, use a twisting motion to pull the plastic casing away from the body of the phone.

    • Continue to move around the phone counter clockwise until the casing is separated from the body.

    • It is not unusual for it to pop off before making it back to the starting point.

  6. Motorola W385 Top Logic Board Replacement: paso 6, imagen 1 de 1
    • If the casing has not popped off of the body, remove it carefully from the the phone.

  7. Motorola W385 Top Logic Board Replacement, Top Logic Board: paso 7, imagen 1 de 1
    • After completing Steps 3-6 in the casing repair guide, your phone should look like this.

  8. Motorola W385 Top Logic Board Replacement: paso 8, imagen 1 de 3 Motorola W385 Top Logic Board Replacement: paso 8, imagen 2 de 3 Motorola W385 Top Logic Board Replacement: paso 8, imagen 3 de 3
    • Use the spudger to unhinge the four clips around the metal casing of the top logic board.

    • Gently take off the metal casing of the logic board.

  9. Motorola W385 Top Logic Board Replacement: paso 9, imagen 1 de 3 Motorola W385 Top Logic Board Replacement: paso 9, imagen 2 de 3 Motorola W385 Top Logic Board Replacement: paso 9, imagen 3 de 3
    • Use spudger to gently disconnect the ribbon cable from phone.

    • Gently remove Logic Board making sure not to damage any other components.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Javier Mendez

Miembro Desde 01/21/10

13 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 8-50, Regan Winter 2010 Miembro de Cal Poly, Team 8-50, Regan Winter 2010

CPSU-REGAN-W10S8G50

3 Miembros

14 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 2,517