Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using your finger, press down on the clip holding the back cover on.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the spudger or your finger, gently pull the battery out from the top.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four rubber pieces from the face of the phone using the sharp end of the spudger.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four Torx-6 screws from underneath the rubber pieces.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Close the phone before proceeding.
-
Using the flat end of the spudger, insert it under the plastic at the top left of the phone.
-
Gently, although a small amount of force is required, use a twisting motion to pull the plastic casing away from the body of the phone.
-
Continue to move around the phone counter clockwise until the casing is separated from the body.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
If the casing has not popped off of the body, remove it carefully from the the phone.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.