Dificultad
Difícil
Pasos
7
Tiempo Requerido
- Battery 2 Pasos
- Logic Board 5 Pasos
Balas!
Mejor coordinación con marcas y color/tipo de balas ayudarán a hacer esta guía más clara!
Herramientas Incorrectas
Ayuda a mejorar esta guía mejor usando las herramientas correctas en imágenes y/o texto.
Introducción
This guide shows how to replace the logic board.
Herramientas
Partes
-
Remove battery cover by pushing down release lever at top of phone while prying off cover.
-
Set cover aside.
-
Remove battery by grabbing it near the bottom and lifting out.
-
Unscrew four corner screws with T6 screwdriver.
-
Note: The two top screws are short and silver. The two bottom screws are black and long.
-
-
Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift.
-
Starting from left side of phone, remove side buttons and place aside.
-
Note: There should be three buttons. One on each side, and the top.
-
-
Return phone to starting orientation when done.
-
Gently remove orange ribbon cable by prying up with spudger.
-
Use a spudger to pry up logic board by wedging in between logic board and chassis and lifting.
-
Note: Orange ribbon cable is fragile and can be broken.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Equipo
Cal Poly, Team 8-48, Regan Winter 2010 Miembro de Cal Poly, Team 8-48, Regan Winter 2010
CPSU-REGAN-W10S8G48
4 Miembros
13 Guías creadas
