Introducción

This guide describes how to replace the button key board, or the processor that interprets key pad information.

Remove battery cover by pushing down release lever at top of phone while prying off cover.
  • Remove battery cover by pushing down release lever at top of phone while prying off cover.

  • Set cover aside.

Agregar Comentario

Remove battery by grabbing it near the bottom and lifting out.
  • Remove battery by grabbing it near the bottom and lifting out.

Agregar Comentario

  • Unscrew four corner screws with T6 screwdriver.

    • Note: The two top screws are short and silver. The two bottom screws are black and long.

Agregar Comentario

  • Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift.

Agregar Comentario

  • Starting from left side of phone, remove side buttons and place aside.

    • Note: There should be three buttons. One on each side, and the top.

  • Return phone to starting orientation when done.

Agregar Comentario

  • Gently remove orange ribbon cable by prying up with spudger.

Agregar Comentario

  • Use a spudger to pry up logic board by wedging in between logic board and chassis and lifting.

    • Note: Orange ribbon cable is fragile and can be broken.

Agregar Comentario

  • Insert spudger under button board and gently lift, set aside.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Eric Freeman

Miembro Desde 26/01/10

1 Reputación

13 Guías creadas

Equipo

Cal Poly, Team 8-48, Regan Winter 2010 Miembro de Cal Poly, Team 8-48, Regan Winter 2010

CPSU-REGAN-W10S8G48

4 Miembros

13 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 1,278