Repara tus cosas Comunidad Tienda

Motorola V557 Screen Replacement

Introducción

The screen is a common breaking point for cellular phones, and can be replaced to repair an unusable phone.

Qué necesitas

  1. Motorola V557 Screen Replacement, Faceplate: paso 1, imagen 1 de 3 Motorola V557 Screen Replacement, Faceplate: paso 1, imagen 2 de 3 Motorola V557 Screen Replacement, Faceplate: paso 1, imagen 3 de 3

    • Remove the four rubber stoppers from around the screen with a pin to reveal four screws.

    Traducir

  2. Motorola V557 Screen Replacement: paso 2, imagen 1 de 2 Motorola V557 Screen Replacement: paso 2, imagen 2 de 2

    • Remove the four 3.8 mm T-6 Torx screws.

    Traducir

  3. Motorola V557 Screen Replacement: paso 3, imagen 1 de 2 Motorola V557 Screen Replacement: paso 3, imagen 2 de 2

    • Separate the cover from the edges using a plastic opening tool.

    Traducir

  4. Motorola V557 Screen Replacement: paso 4, imagen 1 de 2 Motorola V557 Screen Replacement: paso 4, imagen 2 de 2

    • With the edges separated, close the phone and lift off the faceplate with your fingers.

    Traducir

  6. Motorola V557 Screen Replacement, Camera: paso 5, imagen 1 de 1

    • Gently peel off the plastic film from the metal plate above the camera lens as shown.

    Traducir

  7. Motorola V557 Screen Replacement: paso 6, imagen 1 de 2 Motorola V557 Screen Replacement: paso 6, imagen 2 de 2

    • Insert the spudger into the slots marked and gently pry upwards to remove the metal cover.

    • Repeat the previous bullet for the two corresponding tabs on the opposite side of the phone.

    Traducir

  8. Motorola V557 Screen Replacement: paso 7, imagen 1 de 2 Motorola V557 Screen Replacement: paso 7, imagen 2 de 2

    • Lift and peel back the tape attaching metal casing to body of the phone.

    • Gently lift the metal cover and remove to expose the circuit board.

    Traducir

  9. Motorola V557 Screen Replacement: paso 8, imagen 1 de 2 Motorola V557 Screen Replacement: paso 8, imagen 2 de 2

    • Using a plastic opening tool, pry or lift open the pink door shown.

    • After the door is open, gently pull on the ribbon cable's corner to separate it from the board.

    • Work out the ribbon cable's end slowly and gently to avoid damaging the pink door port.

    Traducir

  10. Motorola V557 Screen Replacement: paso 9, imagen 1 de 3 Motorola V557 Screen Replacement: paso 9, imagen 2 de 3 Motorola V557 Screen Replacement: paso 9, imagen 3 de 3

    • Use a plastic opening tool to dislodge and remove the rubber camera cover.

    Traducir

  11. Motorola V557 Screen Replacement: paso 10, imagen 1 de 2 Motorola V557 Screen Replacement: paso 10, imagen 2 de 2

    • Lift the top ribbon cable, with camera attached, up and away from the rest of the phone.

    Traducir

  12. Motorola V557 Screen Replacement, Screen: paso 11, imagen 1 de 3 Motorola V557 Screen Replacement, Screen: paso 11, imagen 2 de 3 Motorola V557 Screen Replacement, Screen: paso 11, imagen 3 de 3

    • Pull the ribbon cable up and out of the way to get access to the circuit board-screen unit.

    • Using a plastic opening tool, gently pry and remove the circuit board-screen unit in both screens.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 7 otros colaboradores

Blair Frandeen

Miembro Desde 10/02/10

19 Reputación

4 Guías creadas

Insignias: 5

+ 2 más insignias

Equipo

Cal Poly, Team 7-50, Amido Fall 2010 Miembro de Cal Poly, Team 7-50, Amido Fall 2010

CPSU-AMIDO-F10S7G50

4 Miembros

24 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 2,735