Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
First, on the back of the phone find the silver button on the top left corner of the phone.
-
Simultaneously push down the button and slide the back plate down to reveal the battery.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grab the lower edge of the battery at the two bottom corners.
-
Pull upward on the edges to remove the battery.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four rubber stoppers from around the screen with a pin to reveal four screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Separate the cover from the edges using a plastic opening tool.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
With the edges separated, close the phone and lift off the faceplate with your fingers.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently peel off the plastic film from the metal plate above the camera lens as shown.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert the spudger into the slots marked and gently pry upwards to remove the metal cover.
-
Repeat the previous bullet for the two corresponding tabs on the opposite side of the phone.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift and peel back the tape attaching metal casing to body of the phone.
-
Gently lift the metal cover and remove to expose the circuit board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a plastic opening tool, pry or lift open the pink door shown.
-
After the door is open, gently pull on the ribbon cable's corner to separate it from the board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a plastic opening tool to dislodge and remove the rubber camera cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the top ribbon cable, with camera attached, up and away from the rest of the phone.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the ribbon cable up and out of the way to get access to the circuit board-screen unit.
-
Using a plastic opening tool, gently pry and remove the circuit board-screen unit in both screens.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pry the speaker out of the case by wedging a pin under the wire mesh.
-