Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
-
Introduce la herramienta de expulsión de la tarjeta SIM en el orificio del lateral de la bandeja de la tarjeta SIM y empuja para expulsar la bandeja.
-
Retira la bandeja de la tarjeta SIM.
-
-
-
Introduce una herramienta de apertura de plástico en la costura entre las tapas delantera y trasera, cerca de la ranura para la tarjeta SIM.
-
Desliza la herramienta de apertura de plástico a lo largo de la costura hacia la esquina superior.
-
-
-
-
Calienta un iOpener y colócalo sobre el teléfono durante unos 90 segundos para aflojar el adhesivo que sujeta la tapa trasera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the five 3 mm T3 Torx screws from the headphone jack/speaker assembly.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert a spudger under the panhandle of the headphone jack/speaker assembly and pry it up from its recess.
-
Remove the headphone jack/speaker assembly.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert the tip of a spudger into the headphone jack and lift upwards to pry the headphone jack out of the display assembly.
-
Remove the headphone jack.
-
Cancelar: No complete esta guía.
7 personas más completaron esta guía.
3 comentarios
Getting the back of this thing was scary. I had to use iOpener (or equivalent) device. Work on the back. Reheat it and let it sit for 90 seconds again. Work on the back some more. I did that 3 or 4 times. I still felt like I was going to break the back, the plastic is MUCH more flexible than I though, and MUCH thinner.
Take your time! Once you get the back off, the rest is a snap!
The instructions are very precise and the pictures clear and sharp! Thanks for writing the instructions!
Great, everything is working perfectly now. I enjoyed this moment to clean speaker and lens which were so dirty. The only hard step is to remove the back. I advice not using a tool when you’ll unstick this thing, you might damage some component. Separate the back from the phone using your fingers and be very careful to not tear off the mobile computing system. It may remain sticked to the back. Finally, don’t throw away your former head jack before installing the new one. You may have to re-use its flexible platic cover if the one provided with your new headphone jack doesn’t fit in the compartment.
Thanks to the author of this guide which gave me the courage to execute this replacement by myself!