Repara tus cosas Comunidad Tienda

Motorola Moto Q Back Casing Replacement

Introducción

This guide will show you step-by-step how to replace the back casing.

Qué necesitas

  1. Motorola Moto Q Back Casing Replacement, Back Casing: paso 1, imagen 1 de 1

    • Use the Push Pin to remove the rubber screw covers by pushing the needle into the rubber and pulling up.

    • Be careful not to poke yourself when handling the push pin because it is very sharp.

    Editar

  2. Motorola Moto Q Back Casing Replacement: paso 2, imagen 1 de 1

    • Use the T6 screwdriver to remove the four screws holding the casing together.

    • Note: they are in the same place where you removed the four rubber coverings

    Editar

  4. Motorola Moto Q Back Casing Replacement: paso 3, imagen 1 de 2 Motorola Moto Q Back Casing Replacement: paso 3, imagen 2 de 2

    • Wedge the plastic opening tool in between the top and bottom cases. This may require a little or a lot of force so be careful.

    • Note: the phone should be face up and the plastic opening tool should be face downwards

    • Once you get the plastic opening tool in, slide it across the side of the phone, making sure to keep the plastic opening tool wedged in between the two casings.

    • Repeat the 3 steps above for the top, bottom, and opposite side.

    Editar

  5. Motorola Moto Q Back Casing Replacement: paso 4, imagen 1 de 2 Motorola Moto Q Back Casing Replacement: paso 4, imagen 2 de 2

    • Gently lift and remove the back casing.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 6 otros colaboradores

Luis Herrera

Miembro Desde 01/21/10

52 Reputación

4 Guías creadas

Insignias: 12

+ 9 más insignias

Equipo

Cal Poly, Team 16-33, Maness Winter 2010 Miembro de Cal Poly, Team 16-33, Maness Winter 2010

CPSU-MANESS-W10S16G33

4 Miembros

10 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 1

Todo El Tiempo: 5,143