Saltar al contenido principal

Motorola MBP667CONNECT Camera Stand Replacement

Qué necesitas

  1. Motorola MBP667CONNECT Camera Stand Replacement, Camera Stand: paso 1, imagen 1 de 2 Motorola MBP667CONNECT Camera Stand Replacement, Camera Stand: paso 1, imagen 2 de 2
    • Remove two 5 mm Phillips #1 screws from the bottom of the camera stand.

  2. Motorola MBP667CONNECT Camera Stand Replacement: paso 2, imagen 1 de 1
    • Use a nylon spudger to remove the casing.

  3. Motorola MBP667CONNECT Camera Stand Replacement: paso 3, imagen 1 de 1
    • Remove the two 5 mm Phillips #1 screws attached to the black plastic under the casing.

  4. Motorola MBP667CONNECT Camera Stand Replacement: paso 4, imagen 1 de 2 Motorola MBP667CONNECT Camera Stand Replacement: paso 4, imagen 2 de 2
    • Remove the black circular plastic part.

  5. Motorola MBP667CONNECT Camera Stand Replacement: paso 5, imagen 1 de 1
    • Remove the white plastic wire housing beneath the black plastic.

  6. Motorola MBP667CONNECT Camera Stand Replacement: paso 6, imagen 1 de 2 Motorola MBP667CONNECT Camera Stand Replacement: paso 6, imagen 2 de 2
    • Now, remove the bottom of the stand by pulling it from the camera.

Conclusión

To reassemble your device, follow these instructions in reverse order.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 3

Todo El Tiempo: 554