Introducción

This guide will instruct you in proper cellphone disassembly and removal of the faulty logic board for replacement.

Partes

No se requieren partes.

  1. Wedge the opening tool in-between the back cover and the body of the phone in the opening denoted by the arrow.
    • Wedge the opening tool in-between the back cover and the body of the phone in the opening denoted by the arrow.

    Agregar Comentario

  2. Once wedged in the opening, slide the opening tool around the side of the phone and remove the back cover, setting it aside.
    • Once wedged in the opening, slide the opening tool around the side of the phone and remove the back cover, setting it aside.

    Agregar Comentario

    • Insert the opening tool between the battery and the battery holder and wedge the battery out.

    Agregar Comentario

    • Open the plastic cover with your finger to expose the SD card.

    • Use the opening tool to grab the edge of the SD card and pull it straight out.

    Agregar Comentario

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • Remove the six 6mm T4 screws with the T4 torque driver.

    Agregar Comentario

    • Pop out the volume button with the plastic opening tool.

    Agregar Comentario

    • Wedge the plastic opening tool in-between the plastic layer and the front cover.

    • Do not completely separate the two pieces to avoid damaging the ribbon cable inside.

    Agregar Comentario

    • Carefully separate the bottom piece from the top plastic piece.

    • Disconnect the ribbon cable connecting the display to the logic board by firmly pulling the cable straight outward.

    • The screen can now be removed.

    Agregar Comentario

    • Separate the logic board and the display cover from the back cover and orient the logic board so the camera faces toward you.

    • Disconnect the back cover by wedging the plastic opening tool in between the motherboard and the connector and prying outward.

    Agregar Comentario

    • Flip the logic board and display cover over so the camera faces away from you.

    • Bend the two halves of the device away from you to pry the final ribbon connector off the logic board.

      • The ribbon connector is bonded to the logic board with adhesive, simply pull it to break the glue bond.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

No Name

Miembro Desde 21/04/13

25 Reputación

1 Guía escrita

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 3

Todo El Tiempo: 1,187