Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Torx T5 screwdriver, remove both screws near the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the Torx T5 screwdriver, remove all 7 screws around the mobile: 3 on each side + 1 on the botton.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a plastic opener tool, open the device removing the back cover.
-
Remove the power button and volume button.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After opening the device, carefully, using the plastic opening tool, peel off the lcd and digitalizer conectors from the mainboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two yellow rubber protectors near the screws. The rectangular yellow rubber protector might fall off too so put it aside.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Separate the Frame + Digitizer, the LCD and the mainboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Now, using a plastic opening tool, carefully insert it between the frame and the glass and force it slowly to remove the adhesive. You may also heat it to help.
-
Now, Remove the rest of adhesive from the frame to better apply the new digitizer on it.
-
Follow this backwards to reassemble the mobile.
-
Cancelar: No complete esta guía.
11 personas más completaron esta guía.